Category: Current House

I Just Dyed in Your Arms Tonight

Published on by Our Humble Abode30 Comments

After hemming and ironing longer than I would have liked, I finished the curtains yesterday.  And I’m now convinced I need to invest in a higher quality iron.  Apparently, the ten-dollar one I have isn’t fit to iron curtains, hence the hours of ironing.  But let’s start at the beginning.  As I pointed out yesterday, we needed a way to take the curtains down without removing the rod.  Why?  This might explain it.

Rather than going the conventional rod route, Ben and I agreed it would look cool to use galvanized pipe for the living space.  Once attached to the wall, it will be difficult to remove just the rods.  The living room window is 125 inches wide, which means we need a looooong curtain rod and extra wide curtains.  When looking for 144 inch rods, its slim pickin’.  Target didn’t have anything longer than 120 inches.  Home Depot had 144 inch rods, but all are more traditional looking that we wanted, like this one that was $45.  However, our Home Depot doesn’t carry that same rod in a shorter length.

So I called Ben while shopping to see what he thought of pipes turned industrial curtain rod.  Luckily, he was down for it.  We discussed the sizes available and came up with three flanges, three 3 1/2 inch nipples (I can tell men named these parts), two 90 degree elbows, and one tee, all 1/2 inch diameter per window.  The larger living room window needed 72 inch long pipes, while the shorter dining window was fine with 60 inch pipes for the rods.

Using a flange, nipple, and tee in the center of each window gives an extra support and allowed us to use two shorter lengths of pipe.

Ben was apprehensive about using drop cloths for the fabric, but I told him it would be okay, so he trusted me.  I walked out of Home Depot $163.76 lighter (dang pipes are expensive) with curtain and rod material in hand.  Now the pressure was on.  I actually had to make these look good.  A quick stop at Joann fabric for three boxes of black fabric dye and I was ready to get to work.  The process of sewing wasn’t difficult, just time-consuming, including a ton of measuring.

With the top, sides, and snaps done, I decided to dye the panels before ironing and hemming the bottoms.  I really wanted a medium gray color, but Joann had light gray and black dye.  Black was my best bet to get a mid saturation, so I mixed one and a half boxes of powder dye with a huge bucket of hot water.  I’m not sure how many gallons, but trust me when I say it was huge.  Then I soaked each panel, one at a time until the colors seemed uniform.  Because I was alone with the boys, I didn’t time anything, just left each panel in a while until it seemed to reach maximum saturation.  Then into the washer for a short, cold wash and a toss in the dryer.  Quite pleasantly, all panels seemed to match and didn’t have uneven spotting.  Success!

And here are the washed, measured, sewn, tabbed, snapped, dyed, hemmed, and ironed curtains in place.  Looking lovely, if I might add.

Each panel barely grazes the floor.

Back tabs are the shiz.  Look how nicely the panels bunch and hang.

But there is one small downside.  Even though the drop cloths are marked 9 by 12 feet, they’re actually about 8 1/2 by 11 1/2 feet.  Straightening up the edges and adding about one foot of rod length makes the large window panels look short when closed.  Oh well, the window is covered and that’s what really matters, right?

The dining panels are perfect though.

You can kind of see that I didn’t make panels for the French doors out to the deck.  When we replace the windows (which will probably happen next summer), we’re changing things up.  No more door there.  Muhahahaha (that’s my evil villain laugh).

Now if we could just get a dining table.  And a light.  Ha.

Can you tell I’m excited about the new curtains?  I’m loving the warmth they add to the room.  Just makes it look lived in.

Mission accomplished.  We’ve got (pretty) curtains.

And here’s what it cost us:

For living room:  $33.90 for two 72 inch long pipes, $2.24 for one tee, $18.72 for three flanges, $3.12 for two elbows, $4.38 for three 3 1/2 inch nipples, $21.98 for a 9 by 12 foot drop cloth, and $2.29 for one box of fabric dye for a total of $86.63

For dining room:  $27.40 for two 60 inch long pipes, $2.24 for one tee, $18.72 for three flanges, $3.12 for two elbows, $4.38 for three 3 1/2 inch nipples, $21.98 for a 9 by 12 foot drop cloth, and $2.29 for one box of fabric dye for a total of $80.13

If I had bought two standard curtain rods, I would have spent 90 bucks on rods, so basically four curtain panels cost about 75 bucks.  Not too shabby.  But I’m not completely done yet.  I think I’ve decided what I want to do, so I’ll be back with more details when I actually get around to that.

Do you have odd sized windows to work with?  Have you used pipes for curtain rods?  Drop cloths for curtains?

Sewing Curtains is Sew Not Fun

Published on by Our Humble Abode7 Comments

I don’t know why, but I’m not a fan of sewing curtains.  No wait, I do.  Large pieces of fabric, lots of measuring, even more pinning, and ironing are all involved.  That’s not to say I don’t like the result, it’s just getting there that I don’t love.  We decided to leave the curtains with our first house, which means I’ve sewed curtains recently.  Until this weekend, we have been curtainless in the living and dining rooms, moving our heads to escape the glare of on the tv.  Nothing like a Lost marathon to light the fire to get these done.  Oh, and I finally formulated a plan to cover our ten and eight foot wide windows.

It all started with a trip to Home Depot, where I bought all the curtain supplies.  Ben and I decided on a less conventional rod system, which meant I had to figure out a way to hang the curtains without removing the rod.  More on that later.

Anyway, this started out with two 9 foot by 12 foot canvas drop cloths, washed with vinegar added to soften the fabric, and cut in half to make four 6 foot by 9 foot panels.  I always start by sewing the sides of curtains.  After doing that to all four panels, I got started on the tops.  Here’s a little trick I like to use to make sure things are as square as possible.  First, I line my hemmed edge along a rug.  Then, I pull the top over enough to fold it over. Starting at the center, I carefully fold the fabric over, keeping the edges of the fabric flush with the edge of the rug.

Then I cut off the excess fabric, including angling the corners to cut the bulky seams.

For a clean, finished edge, I fold the fabric over again, using a line in the rug to keep this even, too.  Of course a measuring tape would also work.  Haha.

Here’s where the easy removal without taking the rod off comes in.  I considered buying curtain clips, but decided not to because I didn’t want to buy five or more packages to work with the extra wide panels.  Instead, I started by sewing ribbon tabs, just like I did for the boys’ curtains.  Of course the tabs aren’t removable, so I sewed only the top of each.

Ben has heavy-duty snaps left over from his leather working days, so I used those on the bottom of each tab.  Each snap consists of four pieces;  two posts (on the left and right), a male, and a female piece (real names, by the way).

After punching a hole in the ribbon tab, I poked the post through, then set the female end on top.  Several taps with the setter and a hammer pushes the post down, clamping the female piece in place.

To mark the other piece, I folded the ribbon back and made a dot where the snap sat.

I found the easiest way to make the holes in the fabric was with an eye hook, screwing it through.

The post goes on the outside of the curtain, with the male piece on top.  Tap it in place and snap together.

I’m really impressed by how strong the snaps are.  Seven hold up the weight of the curtains just fine.

I actually like the ‘studded’ look the snaps have on the front of the panels, too.

Just a little dose of edge/industrial.

Now that we’ve got them hung, I need to measure and hem the bottoms.  I suppose I should iron the panels while I’m at it, then time for a full reveal.  Guess I know what I’m working on today.

Gimme a Giveaway: Lemonade Makin’ Mama

Published on by Our Humble Abode99 Comments

This giveaway is closed.  Thanks for entering!  See who won here.  

Everyone hates those bright yellow dandelions sprouting up in their yard.  But who can resist those puffy seed balls that form after.  I understand they’re only spreading dandelions, but they’re adorable.  And even more adorable are these napkins from Lemonade Makin’ Mama.

Adorable.

While I like the orange, I thought the metallic silver was perfection.

Each napkin has two dandelions with several floating seeds.

Those little floating seeds are my favorite part.  Oh, and the metallic sheen.

These beauties can be yours, so read the details below to enter.

The Goods: One set of silver dandelion napkins from Lemonade Makin’ Mama.

To Enter:  Leave a comment, which can (but doesn’t have to) include our Just for Fun question.

Just for Fun: What do find irresistibly adorable?  Babies?  Puppies?  Buttons?

Contest Closes: Thursday, August 9th at 11:59 pm, central time.

Number of Winners: One!

Ships: Anywhere in the United States.

Other Info: We will select the winner using random.org and announce on Friday, August 10th.  Good luck!!

July Acronym

Published on by Our Humble Abode5 Comments

I know I say this every month, but where has the time gone?  I can’t believe it’s already August.  We’ve got something fun to look forward to and I can’t wait to spill the beans.  Other than that, we’ve got outdoor projects to finish, more to start (and hopefully finish) before the weather cools down.  Although, I can’t lie.  We’re looking forward to fall temperatures.  Steady temps in the upper 90’s and lower 100’s without rain is more than I can handle for this long.  I think my Scandinavian roots are rebelling right now.  But that in no way means I’m ready for winter, so hold off, Mother Nature (please)!

Anyway, enough of my blabbing.  Here’s what we accomplished this July.

Join the festivities:  Free firework prints and a quick Americana table setting.

Unleashed:  A custom pillow tutorial which spurred a new item in the shop, this pretty new address stamp, my new towel buying strategy, quick pillow change for the deck mixing blue and orange, and a new (to me) fabric shop in Minnesota.

Loaded up:  Turning a cheap cardboard box into a pretty storage bin, hanging quirky art in the main bathroom, filling my sister’s stair wall with pictures.

Yet another:  Trip to Ikea, sharing their latest and greatest, Home Goods trip with Jen Jones, and a debate over the placement of something (this time a Sky Tube).

Looking back, we didn’t cross big-ticket items off our to do list.  Why did it feel so busy?  Oh, that’s right.  We’ve been busy hosting gaggles of guests, which is always a treat.  Overall, July has been enjoyable.

How was your July?  Care to share your highlight?  Perhaps you went on a fun vacation?  Finished a project?  Did nothing but relax and read?

This Just In

Published on by Our Humble Abode13 Comments

Ever since I unveiled my arrow stenciled pillow cover, I’ve gotten requests to add something like it to the shop.

Over the weekend, I gave you a peek at the four newest members of our Etsy shop.

Today, I’m proud to reveal a new line of pillow covers for your abode.  Meet the new crew, currently available in teal, gray, mustard, and olive.

Let’s get to know them better, shall we?  Each pillow is made from a linen/cotton blend for the luxurious linen look with the ease of cotton.

At 18 inches square, these pillows are the perfect size for a chair, couch, or bed.  And finding pillow inserts is easy because this is a standard size.

All designs are hand stenciled, one small section at a time, making each pillow unique.  Of course, that also means there are small imperfections or areas where the paint seeped under, but that all adds to the charm of a hand made item.

Envelope closures at the back make stuffing and removing the insert easy when it’s time for a wash.  Speaking of washing, linen is actually easy to care for.  Just turn the pillow cover inside out.  Machine wash on a cool, gentle setting with like colors.  Dry on low setting.  Iron if necessary, keeping cover inside out.

Currently, we have four colors ready for purchase, as well as two different sized prints.  Choose the small print for a patterned look, or the large print for a bolder, graphic look.  Like what you see?  Head over to get one for yourself before we sell out.  Like the idea, but need something a little different?  Send an email to ourhumbleabowed@gmail.com with your color, size, and pattern size preference and we’ll discuss the possibilities.

So, what do you think of the new additions?  Depending on how these are received, I’m excited to add a few more options to the shop and take on custom requests.  What color(s) would you like to see?  Perhaps a different size?  Or a different material?  Share your thoughts to help expand this line, please!